Home/Insights/Recycled PP toughness
RECYCLING

Why recycled PP loses toughness, and how to restore it

It is not simply "recyclate is lower quality". The molecular cause is specific, so the repair is specific too.

Where toughness comes from

PP is semi-crystalline. Its toughness has two contributions: entanglements between long chains in the amorphous region, which can extend, slide and absorb energy under load; and the interface between crystalline and amorphous regions, where fine spherulites distribute stress more evenly.

Recyclate loses the first. Through grinding, washing, drying and pelletising, PP is repeatedly exposed to heat, oxygen and shear, and chains undergo scission. Molecular weight falls. Shorter chains mean fewer entanglement points, so the ability to absorb energy before fracture declines.

This explains why recyclate often keeps acceptable tensile strength but loses notched impact badly — notched impact measures exactly that energy absorption before fracture.

Two repair routes

Route one: elastomer (POE / LLDPE)

The industry standard. Elastomer particles dispersed in the PP matrix act as stress concentrators that initiate crazing and shear bands, dissipating energy. Effective, with clear costs:

  • Modulus falls — the elastomer itself has low modulus, and at 15% the drop is significant
  • Heat resistance falls with it
  • Cost rises — POE is not cheap and the loading is high
  • Flow worsens — melt viscosity rises, processing gets harder

Route two: change crystal morphology (targeted nucleation)

This route does not touch molecular weight; it changes crystal structure. Molecular-scale nucleation produces finer, more complete crystals, and the crystalline-amorphous interface distributes stress.

The key difference: no low-modulus component is introduced, so modulus does not fall. In fact, higher crystallinity pushes modulus up by several percent.

The data

Grade-3 recycled PP, as received: flexural modulus 854 MPa, notched impact 16.05 kJ/m². Both routes add 3%:

RouteFlexural modulusNotched impactAssessment
As received854 MPa16.05 kJ/m²—
+ 3% POE8150836 MPa (−2%)54.57 kJ/m²Higher impact, lower modulus
+ 3% E2801860 MPa (+6%)57.53 kJ/m²Higher impact and higher modulus

The E2801 route exceeds virgin K8003 (impact baseline around 53 kJ/m²).

Why nucleation is not necessarily more expensive

Per kilogramme, the functional masterbatch usually costs more than POE. On total cost the picture differs:

  • Loading is 3% versus 15% — a five-fold difference in quantity
  • Modulus does not fall, so no additional reinforcement is needed
  • Cycle time falls 42% and daily output rises 72% — usually larger than the material cost gap
  • Part weight can drop 20%, saving material directly

The right comparison is cost per part, not price per kilogramme.

When POE is still the right answer

Honestly: for very low temperature impact (below −40 °C), or where very high elongation is required, the elastomer route remains more reliable. We do not recommend replacing POE everywhere — run a comparative trial and let the data decide.

Test it before you price it

Tell us your resin grade, processing temperature, part thickness and the property you need to improve. We recommend a grade and dosage, ship 1–5 kg, and follow up with comparative data.

Or call Mr. Luo +86 135 5407 7117 +86 130 0101 5295

Request a sample